This section will outline the steps required to install a surface mount PlacePod physically.
PREPARING PARKING SPOT
1. Clear any debris in the parking space with the deck broom.
2. Clean center of parking space(s) using locally available asphalt/concrete cleaner and stiff
bristle scrub brush.
3. If necessary, remove the sealer from the pavement surface in the area where the sensor is to be
placed and repeat steps 1 & 2 above.
- This is necessary for a longer-lasting bond.
- The sealant layer can de-laminate from pavement while remaining attached to the sensor
housing.
4. Mark the center of each space using the chalk snap-line.
If you intend to screw the PlacePod down to the pavement, follow the steps below.
5. Place the PlacePod Surface Mount hole pattern, provided at the end of this document, at the center of the spot and mark each screw hole location. Alternatively, you can use the PlacePod housing to mark the holes through the housing. ONLY mark the holes through the housing, do NOT drill the holes through the housing.
6. Use the Hammer Drill to drill the screw holes. Do NOT drill the holes through the PlacePod sensor as the vibration and shock from the drill can damage the components inside the sensor.
PREPARING PLACEPOD FOR ADHESIVE
1. Using coarse sand paper, lightly sand the bottom grey portion of the housing, scuffing the surface.
2. Wipe off any residual particulates from the sanding.
INSTALL PLACEPOD WITH ADHESIVE
1. If the mapping of the sensor location is being performed, record the Serial Number.
2. At a minimum, apply a 1/8” to 1/4” bead of adhesive around the outer and inner rings of the
PlacePod.
3. If desired, adhesive can be applied to the ribs and to the sensor lower housing (black) areas NOT
covered by the label.
4. To optimize signal strength, orient the sensor in the middle of the space such that the arrow points towards the nearest gateway.
5. Place the sensor on the ground and press down on it firmly.
6. If desired, apply an additional bead of adhesive around the seam of the sensor and the
pavement.
Note: If you intend to also screw the PlacePod down, ensure that you align the PlacePod with the pre-drilled screw holes.
INSTALL PLACEPOD WITH SCREWS
1. Use the PlacePod hole pattern diagram below to mark your pre-drilled screw holes.
2. Align the PlacePod in the center of the parking space with the pre-drilled screw holes.
3. Screw the PlacePod down with the Masonry Screws and hand tighten. Do not over-tighten the
screws as this can damage the PlacePod housing.
Note: Drilling dimensions - Drill bit size is determined by screw manufacturer.
POST-INSTALLATION STEPS
After the PlacePod has been successfully installed there are some additional steps that should be taken.
1. Verify that the PlacePod is communicating with the LoRa network.
2. Calibrate the PlacePod sensor for the empty parking space. This is important and
required for each sensor. If calibration is not properly performed the PlacePod will not accurately detect vehicles.