Where to install the product

Recommended places

The equipment should be placed in a location representative of average exposure. Ideally, the product should be placed in a central location in the room, between 50cm and 2m high. Try to place it away from draughty areas (doors, windows, etc.) and away from areas close to heat sources (radiators, direct sunlight, etc.).

Places to avoid

- Less than 30 cm from the ceiling

- In the open air

- In a place where the temperature is below 0°C or above 50°C

- In a place where the humidity level is higher than 95% (bathroom, kitchen, laundry room, etc.) - In a dusty or dirty place (garage, workshop, etc.)

How to install the product

Description of the assemblies

Mounting the detector on a wall

First of all, you have to choose if you want to activate the anti-theft system or not. If not, you can go directly to the section: installation of the mounting base.

Activate and remove a product installed with the anti-theft system

If you want to activate the anti-theft system, you have to break the tab of the fixing base with pliers.

To remove a product with an activated anti-theft system, use a screwdriver to continuously push on the

tab and rotate the product.

Installation of the mounting base

Use the mounting base and the screws and plugs supplied with the detector. The product can also be mounted using the adhesive fasteners.

For screw mounting :

Mark the preferred location of the screw holes on the wall with a pencil. The drawing on the inside of the base shows the final position of the detector when attached.

Insert the supplied nylon plugs and screw on the mounting base

In case of adhesive mounting :

Place the adhesive on the mounting base and press with your finger for 10 seconds.

Remove the adhesive protection and stick the mounting base to the wall. Push with your fingers for 10 seconds. Wait 30 seconds: The adhesive works!

Place your detector on the mounting base, then turn it a quarter turn to the right to secure it. You should hear a "click", indicating that your detector is secured in its mounting base.

Check that your detector is securely mounted on the wall.

Free standing

Use the mobile mounting base supplied with the detector.

Follow the procedure below:

Place the detector on a piece of furniture or a shelf within one meter of the floor to prevent damage if the detector is accidentally dropped.

Place your mobile mounting cradle on the back of the detector, then turn it a quarter turn to the right to secure it. You should hear a "click" sound, indicating that your detector is secured in its mobile mounting

base.