Liability INESO cannot be held liable for any damage that occurred during the shipment of the equipment or during installation if it is done by personnel that does not hold the proper certification from the competent authorities. It is the customer’s responsibility to find competent personnel that can install and maintain the electrical installation. Safety The installer must scrupulously follow the installation instructions, and use the equipment as planned, within the recommended current limit. The replacement of the sensor is on the responsibility of the customer and is not recommended by Ineso. If there is a need to replace the sensor, we encourage you to contact Ineso to send products to replace them.
In order to replace the sensor, it will be necessary to have:
- A cruciform screwdriver
- A new sensor
- Clean space
1. Remplacement du capteur
Disconnect the device from the power supply. Turn the sensor backwards and locate the four fixing screws. Then unscrew them.
Locate the sensor and cables connected to the sensor
Gently disconnect the cables and replace the sensor
Please pay attention to the socket, after connecting you must hear a characteristic sound, if necessary, use a screwdriver to tighten. Check the right connection
Close the cover and pay attention to the rubber seal around the device. It must be evenly distributed.
Tighten the four mounting screws. The replacement of the sensor is finished.